China copper tubes suppliers

5 minutes to cut the workpiece with conventional copper wire for 60 minutes, which is a relative increase of nearly 29%.001 mm◎ Maximum cutting taper 30°/87 mm◎ Active wire threading through the thread organization, enclosed diamond guide nozzle◎ CNC 5-axis linkage, 6-axis controllable◎ Surface roughness 0.

And for different cutting methods, different thicknesses of the cut workpieces, the reflected changes vary greatly, from 9% to 50%. Not only in terms of production speed and surface quality integrity, we have achieved results that cannot be compared in the traditional sense of electrical manufacturing, and now economic research is also very active. If the other factors are summarized, when the unit hour cost of wire cutting is calculated at 30 Euros, the technical economic function comparison including operating cost is summarized, and calculated at 15 hours a day, the use cost of coated copper wire can be saved compared with conventional copper wire.04 Euro/hour respectively. The test shows that when the cutting speed of coated copper wire ((Cu)CuZn50) is increased to the optimal speed of 10 m/min, and the optimal cutting speed of the corresponding conventional copper wire is 8m/min, the cost of copper wire

They are 2.3 ～0. Comparing the results of the study, it is shown that the overall effect of the existing coated copper wire is better than the conventional copper wire (CuZn37).Red copper wire talks about the technical economic function comparison analysis of commonly used copper wire Evaluate the cutting speed and taper cutting habit function of the commonly used EDM wire cutting copper wire in the market, and give its technical economic function analysis.

The comparison China copper tubes suppliers is the maximum incision speed.5 minutes of time saving mentioned in the above calculation can be further considered for the next production mission. The following comparison test was carried out on the ONA AF25 slow-moving thread cutting machine bed. The 13. The research results show that, although the unit cost of copper wire with coating is higher, the cost-benefit ratio of the final result is higher. In the past 10 years, electrical production skills have been rapidly developed. The results of the processing power indicate that it takes 46. Linear incision is the first step. .

Megosztás a facebookon